Some downloads (.zip files) will require a
decompression utility such as WinZip to unpack the files. Get a fully
functional evaluation version here
NX241/NX242 Jumper positions
It occurred to us that if you fit the NXtension board to an
NX241/242, you can't fit it without removing some jumpers inside.
What if you want to remove the board
later? What are the jumper positions to put them back???
The circuit board isn't marked!
The photo below will show you where
they go.
You'll need 7 jumper links.
Counting from the right of the picture, the jumpers are
on pins 3,4,5,6,7, then miss four pins and put two more jumpers on
positions 12 and 13.
Note that the NX241 and the NX242 use the same jumper
positions.
To obtain further information and request
a catalogue, please enter your details into the Information
Request Form
